News
Instructions of Raymond mill, high pressure roller mill, vertical mill
Date:2017-04-24 02:02:27
Raymond mill, high pressure grinding mill and vertical mill is highly efficient powder mill. As a universal milling equipment, do you know what they need to pay attention to in the process?1. Raymond Mill.
Is one of traditional powder mill. Plant and foundation should be installed in accordance with the basis of the size of Raymond Mill size should be sufficient height and installation position, Raymond mill foundation should be used with high grade cement and must be buried in the reinforcement of the foundation can be poured into the pipeline or cable trench. After pouring the cement foundation, there must be 15 days of maintenance. Should be equipped with 2 ~ 3 tons lifting tool for Raymond mill installation and maintenance. Raymond mill from the factory to use for more than 6 months time, the host center axis system, transmission device, roller grinding device, analysis of oil pool etc should be clean and check, cleaning after the examination of each part should add enough oil. When installing Raymond mill, if the operation site has not been installed, should be properly kept, the surface should be coated with anti rust grease, and to avoid the sun and rain, in order to prevent the body rust water, to establish a maintenance system.
2. High Pressure Grinding Mill.
When the air switch of each circuit is automatically cut off, it is necessary to find out the reason and close the air switch. When the grid voltage is lower than 10% should stop working. When the components are damaged and replaced, the corresponding components should be replaced without increasing the capacity. The motor should be maintained in a timely manner, and found that the temperature rise is too high. The current is too large, should stop maintenance.
3. Vertical Mill.
Is one of the new powder mill. The operation and maintenance of the control cabinet should be responsible for the personnel, regularly check the cabinet outside the cabinet, to maintain the instrument is clear and bright, flexible operation handle, contactor, the main electrical shock. Regularly check the components and connections are loose, damaged. Every half a year to measure the insulation resistance, find the problem in time.
Product List
